Comments on: EW21: Lesson 0: Introduction & Resources https://iotexpert.com/ew21-lesson-0-introduction-resources/ Engineering for the Internet of Things Mon, 01 Mar 2021 12:07:40 +0000 hourly 1 https://wordpress.org/?v=6.9.4 By: Harris Chan https://iotexpert.com/ew21-lesson-0-introduction-resources/#comment-87244 Mon, 01 Mar 2021 12:07:40 +0000 https://iotexpert.com/?p=10777#comment-87244 Hi Alan,

I would further elaborate that “At the bottom, the blue box provides +12v to the drone and the PSoC board (if USB is not connected), also provides +5V to the LED strips.”

Just my 2-cents.
Harris

]]> By: Harris Chan https://iotexpert.com/ew21-lesson-0-introduction-resources/#comment-87232 Mon, 01 Mar 2021 03:24:48 +0000 https://iotexpert.com/?p=10777#comment-87232 Hi Alan,

Thank u again for the awesome content! I am now following your step-by-step instructions to recreate the projects.

Just to highlight that the P/N for the XENSIV+XMC MCU board is TLE493D-W2B6 MS2GO (correctly mentioned at the Resources section), whereas the P/N for the XENSIV sensor is TLE493D-W2B6 Ax. There was some mix-up when I ordered thru ISR before so I highlight here to ALL. Hope this helps!

Harris

]]>